Are you having trouble installing car light and then we onto your vehicle? Or maybe you just not sure where all the wires for the under car lights go? Let us show you all the "in's & out's" of this type of installation - which i should mention, is designed with the "Novice" in mind.

The first thing you'll need to do to find where you want to mount the led car light. Be sure to keep their location in mind while doing the wiring part of the installation, so you can allow for the correct lengths of the wires.

You'll also need to disconnect the battery before starting on the installation and the drilling of holes. Do this by disconnecting the negative battery cable. This led under car lights installation involves disconnecting the battery first and foremost for safety reasons, and so you don't "short-out" your car wiring.

The easiest way to mount the LED car light is to start the screws in the brackets first,(supplied in kit) then holding the bracket in place, insert and tighten the screws into the holes. Make sure that the wires coming from the Side light are facing the front of the vehicle. It's best to tighten the screws just enough to hold the bracket in place, then go back after once you almost finished and individually tighten each one until it seats firmly.

You should have a distribution block in your under car lights kit, find a good location for the block on a flat surface in the engine compartment away from any heat or moving parts.

Next you will need to determine a location inside your vehicle to mount the digital control panel. You want it to be in a location where you can easily access all its buttons and functions while your sitting in the vehicle.